Monday, January 30, 2012

guitar build session 6

All about the neck this week. First job was to attach headstock template, then using a rasp bit in a table mounted router, to route the shape of the headstock around it. Then attach a straight edge template along one side of the neck and route that down to size, same with the other edge. Then some real hard work. To shape the back of the angled headstock roughly, I used a gouge chisel to chop away the surplus, then took it down to almost final shape using a hand rasp. Next we took a lot of the surplus off the back of the neck with an electric planer.

Next job was to route a narrow channel for the truss rod. Just wide and deep enough to take it with very little space around it. We put in the dual action rod then glued and clamped the fretboard in position. Doesn't sound a lot but it took the whole afternoon. Here's a photo just before we put fretboard on.

1 comment:

Raindog951 said...

This must be one of the most ambitious projects yet? Very professionally done so far!